Mark Techpro And Consultants Private Limited

Conventional Gap and Overlap Type Wave Springs are used in a wide variety of applications. For short deflections and low-medium forces, they function with precision and dependability.

These two types of Smalley Wave Springs permit radial expansion or growth in diameter within a cavity, without the binding or hang-up normally associated with die stamped wave washers. Just as their terms imply, the gap type is split to retain a gap between the ends; while the overlap type has overlapping ends. Thus, the ends are free to move circumferentially as the spring outside diameter grows during compression.

Size range:

• Standard : 9 mm to 600 mm diameter
• Custom : 4 mm to 3000 mm diameter

Material :

• Standard : Carbon steel, SS 17-7
• Custom : SS 302, SS 316, Super alloys - Inconel, Monel, A 286, Elgiloy, Beryllium copper

Surface treatment & surface finish as per customer requirement: Black oxide, Zinc plating, Oil Dip, Passivation, Zinc phosphate, Vapor degrease/ Ultrasonic clean, Vibratory deburr/Hand deburr.

Benefits :

• SINGLE TURN WAVE SPRINGS are a better alternative for STAMPED WAVE WASHER.
• WAVE SPRINGS are engineered to perform according to the application needs of the customer to provide accurate & consistent spring force until the life cycle of the assembly.
• No Tooling Charges™ or long lead time for tool development. Very quick delivery.
• Standard sizes & custom sizes are available.